Before starting, carefully check whether the motor, switch, circuit and grounding are normal and firm, and check whether the operating parts and buttons of the equipment are stuck in the correct position.

1. Wear work clothes and tighten cuffs when entering the venue. It is strictly forbidden to play and play and keep the venue clean and tidy.

2. The operation can only be carried out after mastering the correct use of relevant equipment and tools.

3. Before starting, carefully check whether the motor, switch, circuit and grounding are normal and firm, and check whether the operating parts and buttons of the equipment are stuck in the correct position.

4. The parts of the bending machine to be lubricated should be regularly refueled.

5. Operation can only be carried out after checking that the equipment is free from abnormality during idling operation before bending.

6. It is forbidden to drive when installing bending die.

7., the correct choice of bending mold, according to the thickness of the plate to determine the size of the die, the general die size of the plate thickness of 8 to 10 times, 2mm within the thin plate can be 6 to 8 times;

8. The fastening positions of the upper and lower dies shall be correct, and the upper and lower dies shall be installed to prevent trauma during operation.

9. No sundries and measuring tools shall be piled up between the upper and lower dies during bending.

10. When multiple people operate, confirm the main operator, and the main operator controls the use of the foot switch, and other personnel are not allowed to use it.

11. The sheet must be compacted during bending to prevent the sheet from lifting and hurting people during bending.

12. When the machine tool is working, people are not allowed to stand at the rear of the machine tool.

13. If the workpiece or die is found to be not upright during operation, stop the machine for correction. It is strictly prohibited to use hand correction during operation to prevent hand injury.

14. It is forbidden to fold over-thick iron plate or quenched steel plate, high-grade alloy steel, square steel and sheet metal exceeding the performance of sheet metal bending machine, so as not to damage the machine tool.

15. Always check the coincidence of the upper and lower molds; whether the indication of the pressure gauge meets the requirements.

16. Correct selection of bending pressure, eccentric load pressure should be less than ****** pressure 1/2.

17. When the length of the folded plate is less than 1000mm, the machine is not allowed to work at full load.

18. No matter when working or stopping, any part of the human body shall not enter between the upper and lower molds to avoid accidental personal injury.

19. When replacing the lower die, the slider must stop at the bottom dead center, otherwise personal injury may occur.

20. If the bending machine is abnormal, cut off the power supply immediately, stop the operation, and notify the relevant personnel to troubleshoot in time.

21. The slider must be stopped at the bottom dead center before shutting down.

22. After completion, cut off the power supply and clean the work site.