Adjust the processing size as required. Press the calculator button for the rear gear adjustment of the machine tool (long press is required, and stop after reaching the value), and then use a tape measure to review and adjust the size.

I. Labor protection articles must be worn before work, and the coat must not be open.

The machine operator must be familiar with the structure, performance and use of the shearing machine.

III. All electrical facilities and tank potential must be checked before starting up, and the operation can be carried out only after it is determined to be in good condition.

4. After starting the motor, the emergency stop switch button must be tested to be in good condition before formal operation.

5. Confirm the plate thickness before cutting the plate, then adjust the clearance of the cutter plate on the right side of the machine tool and lock it after adjustment.

6. Adjust the processing size as required. Press the calculator button for the rear gear adjustment of the machine tool (press for a long time and stop after reaching the value), and then use a tape measure to review and adjust the size.

VII. Before the machine tool is operated, 1-3 empty strokes should be made, and then shearing work should be carried out after normal operation.

8. When cutting the plate, in order to ensure the right angle of the processed part, the processed part should be close to the left limit block of the machine tool, and then the plate should be cut and the processing button (foot switch) should be started.

9. When the hydraulic plate shearing machine is operating and processing, the hand should be supported, but it is strictly prohibited to put the hand into the guardrail (the cutter plate shearing bar).

X. Processing operations must be focused, and it is strictly forbidden to play with each other.

11. When more than two people operate, the main operator should check the situation of the cooperation personnel before starting, inform them, and start the switch (foot switch) after ensuring that there is no danger.

XII. If the machine is found to be operating abnormally during use, the power supply should be cut off immediately and the machine should be stopped for inspection.

XIII. The power supply must be cut off when adjusting the machine tool, and the safety of the hand should be paid attention to when moving the workpiece.

Fourteen. After the end of the work should cut off the power supply, do a good job of machine tool maintenance and environmental cleaning.